2012 Nissan Navara

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is repaired but structural rigidity is not significantly reduced covered in underseal (6.1.1 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) DANGEROUS

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Lower Suspension arm ball joint has slight play N/S/F and O/S/F (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material N/S/R and O/S/R (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S/R and O/S/R (5.3.6 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Lower Suspension arm ball joint has slight play N/S/F and O/S/F (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material N/S/R and O/S/R (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive N/S/R and O/S/R (5.3.6 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material N/S/R and O/S/R brake pipes on axle (1.1.11 (c))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material N/S/R and O/S/R brake pipes on axle (1.1.11 (c))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Nearside Rear reflector defective or damaged by more than 50% of the reflecting surface (4.8.1 (a) (ii))

Nearside Side repeater with a multiple light source more than 1/2 not functioning (4.4.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Side repeater with a multiple light source up to 1/2 not functioning (4.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Front Tyre worn close to legal limit/worn on edge both front tyres (5.2.3 (e))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides onto hub (1.1.11 (c))

Front Prop shaft joint excessively worn (6.1.7 (c) (i))

Front Tyre worn close to legal limit/worn on edge both front tyres (5.2.3 (e))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides onto hub (1.1.11 (c))

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

rear brake application uneven (3.7.B.2)

Nearside Front Seat belt cut but webbing not significantly weakened (5.2.2a)