2002 MG Zr

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive and outer sill (5.3.6 (a) (i))

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Exhaust rear silencer heat shield insecure

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Exhaust rear silencer heat shield insecure

Nearside Front Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

Nearside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Exhaust rear silencer heat shield insecure

Fuel system component leaking (6.1.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

Nearside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Rear Shock absorbers has slight external damage to the casing corroded (5.3.2 (b))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure long spilt on outer side wall (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front brake caliper leaking (3.6.A.1) DANGEROUS

Nearside Front Tyre(s) incorrect because a lightweight or space saving wheel is fitted (4.1.A.1b)

n/s/r tyre wearing on inner and outer shoulders

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside front brake binding (3.7.B.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Suspension joint nearside lower dust cover split/missing

handbrake has large travel

o/s outer cv gaiter perished

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp insecure (1.7.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Suspension joint nearside lower dust cover split/missing

handbrake has large travel

o/s outer cv gaiter perished

Nearside Stop lamp not working (1.2.1b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)