2003 Volkswagen Beetle

Rear Coil spring corroded both rear spring rusty (5.3.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Inner Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.1 (c) (ii)) DANGEROUS

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Headlamp aim too far to the left (1.8)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)