2004 Citroen Relay

Central Stop lamp(s) showing white light to the rear (4.3.3 (a) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer and inner sill before spring (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill behing leaf spring (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis in front of suspension arm (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch before suspension arm (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill behind leaf spring (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is inadequately repaired outer and inner sill corroded before spring (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

general corrosion front and rear chassis

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Brake hose excessively chafed (1.1.12 (b) (ii))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Tyre worn close to the legal limit both on inner edge (4.1.E.1)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working both (1.1.C.1d)

Front Tyre worn close to the legal limit both on inner edge (4.1.E.1)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Headlamp aim too low (1.8)

Bonnet cannot be secured in the closed position (8.4.1)

Bonnet retaining device ineffective (8.4.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear brake drum contaminated by brake fluid (3.5.1h)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

some noise from front bearings

Brakes imbalanced across an axle (3.7.B.5b)

Centre Rear Stop lamp emits other than a steady red light (1.2.1e)

Headlamp aim not tested (1.8.A.1c)

Nearside Front Macpherson strut upper support bearing is stiff in operation (2.5.B.1b)

Offside Front Macpherson strut upper support bearing is stiff in operation (2.5.B.1b)

Offside Headlamp not working on dipped beam (1.7.5a)