2002 Peugeot 206

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Side repeater incorrect colour (4.4.3 (a))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Brake load sensing valve seized (3.6.E.3)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Offside Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

n/s front top suspensionmount siezed

Front coil spring corroded (2.4.C.1b)

Under-trays fitted obscuring some underside components

Offside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Front coil spring corroded (2.4.C.1b)

Under-trays fitted obscuring some underside components

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

airbag warning light on

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

airbag warning light on

Offside Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

injector seal blowing

Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

injector seal blowing

advise exhaust joint between rear silencer and pipe wearing thin

advise right outer drive shaft gaiter inner clip loose

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Brake load sensing valve linkage seized (3.6.E.3)

advise exhaust joint between rear silencer and pipe wearing thin

advise right outer drive shaft gaiter inner clip loose