2006 Jaguar X-type

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Inner Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

brake fluid low

corrosion to sills ,chassis, subframes, suspension components sill covers fitted preventing full inspection

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion to sills, chassis, sub frames, suspension components - sill covers fitted preventing full inspection

nearside rear tyre heavily worn on edges , deteriorated and underinflated

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

corrosion to sills and suspension components- sill covers fitted

front tyres wearing on inner edges

corrosion to sills and suspension components - sill covers fitted

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

corrosion to sills and suspension components - sill covers fitted

slight corrosion to sills- sill covers fitted preventing full inspection

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front position lamp(s) not working (1.1.A.3b)

slight corrosion to sills- sill covers fitted preventing full inspection

rear tyres wearing low

Engine covers fitted obscuring some components in the engine bay

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside front tyre has a cut in outer sidewall - not reaching cords

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Play in steering rack inner joint(s)

Nearside Headlamp aim too high and too far to the right. (1.8)

Offside Front coil spring broken (2.4.C.1a)

Offside Headlamp aim too high (1.8)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside front tyre has a cut in outer sidewall - not reaching cords

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs inner face corroded

front inner brake pads appear low

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nail in offside rear tyre

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake discs inner face corroded

front inner brake pads appear low

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

o/s/r tyre worn inner edge

Nearside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Inner Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nail in offside rear tyre