2007 Fiat Ducato

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Front Suspension arm attachment bracket/mounting insecure Bolt (5.3.3 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Outer Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area is inadequately repaired Sill (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Crossmember (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear X member / valance corroding

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear X member / valance corroding

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Valve stem slightly damaged (5.2.3 (j))

Offside Rear Valve stem slightly damaged (5.2.3 (j))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill chalked. (6.2.2 (d) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Valve stem slightly damaged (5.2.3 (j))

Offside Rear Valve stem slightly damaged (5.2.3 (j))

Oil leak, but not excessive (8.4.1 (a) (i))

Coolant leak ()

Damp around injector leak off pipes, no physical leak/drip at time of test.

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear wishbone bush. (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill..... (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear, wishbone bush. (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Nail in tyre ()

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak ()

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Fuel system component leaking (7.2.3)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

both rear tyres starting crack on side walls

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Fuel system component leaking (7.2.3)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

both rear tyres starting crack on side walls

2x rear exhaust mounting rubbers getting weak

Nearside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

wiper dont park