2010 Kia Rio

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Suspension arm pin or bush excessively worn Front bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material To rear (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material To rear x2 (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material To rear x2 (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust system not adequately supported (7.1.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)