2012 Audi Q5

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement hyrdo bush (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement hyrdo bush (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Nearside Rear Headlamp levelling device inoperative headlamp level arm broken (4.1.5 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

coolant level minimum

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources os number plate light inopp (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin pads wearing thin (1.1.13 (a) (ii))

Nearside Front Bumper insecure front bumper corner insecure (6.1.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources os number plate light inopp (4.7.1 (b) (i))

Rear Brake pad(s) wearing thin pads wearing thin (1.1.13 (a) (ii))

Nearside Front Bumper mountings corroded but not likely to become detached nsf bumper corner insecure (6.1.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge tyre tread getting low at 2mm (5.2.3 (e))

Offside Rear Nail in tyre ()

Front Headlamp aim too high both front headlamps to high (4.1.2 (a))

Offside Rear Nail in tyre ()

Nearside Front Outer Tyre worn close to the legal limit 2mm (4.1.E.1)

emission's to clean to record (rev limiter

Exhaust emissions to clean to record