2005 Smart (mcc) Forfour

Front Anti-roll bar ball joint has slight play both (5.3.4 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear slightly cracked

crack in screen

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Lower Coil spring corroded (5.3.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Lower Coil spring corroded (5.3.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Stop lamp not working (1.2.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Stop lamp has less than 50% of the light sources illuminating high level (1.2.1b)

Front passenger door cannot be opened from outside the vehicle (6.2.B.1b)

Nearside Front coil spring broken (2.4.C.1a)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Registration plate lamp not working 2x (1.1.C.1d)

Windscreen washer provides insufficient washer liquid 2x (8.2.3)

Anti-roll bar linkage has slight play in a ball joint Both front (2.4.G.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Registration plate lamp not working (1.1.C.1d)

Anti-roll bar linkage has slight play in a ball joint Both front (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n.s.f tyre 3mm

o.s.r tyre nail in tread

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)