MOT Status
ExpiredMileage
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Battery insecure but not likely to fall from carrier (4.13 (a) (i))
Brake pipe corroded, covered in grease or other material front to rear coated in grease (1.1.11 (c))
Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Offside Front Play in steering rack inner joint(s) ()
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))
Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))
general corrosion to under body and sills
Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Battery insecure but not likely to fall from carrier (4.13 (a) (i))
Brake pipe corroded, covered in grease or other material front to rear coated in grease (1.1.11 (c))
Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))
Offside Front Play in steering rack inner joint(s) ()
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both (5.1.2 (b) (i))
Rear Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))
general corrosion to under body and sills
Nearside Front Steering linkage ball joint has excessive play (2.1.3 (b) (i))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))
Service brake efficiency below requirements (1.2.2 (a) (i))
Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))
Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)
Front Sub-frame corroded but not seriously weakened (2.4.G.1)
Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Suspension arm has slight play in a ball joint (2.4.G.2)
outer sills corroded
Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)
Front Sub-frame corroded but not seriously weakened (2.4.G.1)
Fuel system component leaking ? (7.2.3)
Registration plate lamp not working (1.1.C.1d)
Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive (3.6.C.3)
Front Sub-frame corroded but not seriously weakened (2.4.G.1)
Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive chassis (3.6.C.3)
Front Sub-frame corroded but not seriously weakened (2.4.G.1)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
fuel filter wet
Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive chassis (3.6.C.3)
Front Sub-frame corroded but not seriously weakened (2.4.G.1)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Front position lamp(s) not working both (1.1.A.3b)
fuel filter wet
Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)
Supplementary Restraint System warning lamp indicates a fault (5.4.2)
Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS
Offside rear brake recording little or no effort (3.7.B.5a) DANGEROUS
rear brake application uneven (3.7.B.2) DANGEROUS
rear brakes release unevenly (3.7.B.4) DANGEROUS
Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Nearside rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)
Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Brake load sensing valve stiff (3.6.E.3)
Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)
Brakes imbalanced across an axle (3.7.B.5b)
Brake load sensing valve stiff (3.6.E.3)
Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)
Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)
Offside Registration plate lamp not working (1.1.C.1d)
rear tyres cracking slightly
rear tyres cracking slightly
Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)
Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Offside Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)
Front brake disc slightly scored (3.5.1h)
Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)
damp patch gearbox
nearside front wing mirror broken/covered over
slight play inner track arms
How Reliable is the Peugeot Expert?
Based on 1,258,593 MOT tests across 97,542 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
BJ56 CFP is a 2006 Peugeot Expert in White with a 1,997cc diesel engine. This vehicle has been through 21 MOT tests with a personal pass rate of 57.1%.
Across all 2006 Peugeot Expert models, the average MOT pass rate is 68.1% with a typical mileage of 102,139 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Peugeot Expert fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 34,152 recorded failures. If you're considering buying BJ56 CFP, it's worth having these areas checked by a mechanic before committing.
The Peugeot Expert typically stays on UK roads for around 29 years. At 20 years old, this Peugeot Expert is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of BJ56 CFP?
You can check the full history of BJ56 CFP by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was BJ56 CFP registered?
BJ56 CFP is a 2006 Peugeot Expert, first registered on 30 September 2006.
Is BJ56 CFP safe to buy?
The MOT history for BJ56 CFP shows 21 tests with a 57.1% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does BJ56 CFP have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on BJ56 CFP. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.