2007 Audi A6

All exhaust heat shields deteriorated/insecure

Both offside jacking points missing

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both sides - bushes deteriorated (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Front arm (5.3.4 (a) (i))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement Front subframe bush deteriorated (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Rear arm (5.3.4 (a) (i))

Offside Rear Outer Integral body structure is repaired but structural rigidity is not significantly reduced Sill (6.1.1 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement All rear suspension arm bushes deteriorated (5.3.4 (a) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Fuel pipe union leaking Underside (6.1.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn Rear arm (5.3.4 (a) (i))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam Beam pattern not checked (4.1.1 (a) (ii))

Nearside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Nearside Rear Upper Shock absorbers insecurely attached (5.3.2 (a) (i))

Offside Front Body panel corroded and likely to cause injury Lower wing/arch (6.2.1 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt Front arm ball joint dust cover split (5.3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Brake hose excessively deteriorated (1.1.12 (b) (ii))

Offside Rear Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

All exhaust heat shields deteriorated/insecure

Both offside jacking points missing

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both sides - bushes deteriorated (5.3.4 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Front arm (5.3.4 (a) (i))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement Front subframe bush deteriorated (5.3.4 (a) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Rear arm (5.3.4 (a) (i))

Offside Rear Outer Integral body structure is repaired but structural rigidity is not significantly reduced Sill (6.1.1 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement All rear suspension arm bushes deteriorated (5.3.4 (a) (i))

Brake pad warning light on

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pad warning light on

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Electronic stability control switch not functioning correctly (7.12 (d))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn front upper arm (5.3.4 (a) (i))

Offside Rear Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill holed (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement front upper arm (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear upper arm (5.3.4 (a) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear upper arm (5.3.4 (a) (i))

brake wear warning illuminated

corroded and holed at rear of offside front wheel arch

Brake wear indicator light on dashboard

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Suspension arm ball joint excessively worn Rear arm (5.3.4 (a) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Brake wear indicator light on dashboard

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Brake lining warning light illuminated

Offside Registration plate lamp inoperative

Brake warning light on dash

Headlamp warning light on dash

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Brake warning light on dash

Headlamp warning light on dash

Engine bay cover(s) and under-tray(s) fitted obscuring some testable components

Rear Both exhaust heat shields insecure

Suspension arm rubber bush deteriorated but not resulting in excessive movement All four front upper (2.4.G.2)

advise cover missing from hazard light switch

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Headlamp aim too high (1.8)