2007 Subaru Outback

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Brake pedal pivot has excessive wear or free play Noticeable change in pedal as pressure is increased. (1.1.1 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Registration plate does not conform to the specified requirements Insufficient border. (0.1 (d))

Nearside Front Lower Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Lower Steering linkage ball joint ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Headlamp reflector seriously defective When returning to dipped beam from main beam, the shutter does not return to dip the bulb unless the lamp is tapped heavily. This means that the headlamp is liable to dazzle other road users. (4.1.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Headlamp levelling device inoperative Sensor mechanism detached from axle and stiff to operate. (4.1.5 (a))

Brake pedal wearing smooth Also split (1.1.2 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy Aftermarket silencers fitted. (8.1.1 (a))

Nearside Front Lower Steering linkage ball joint has slight play (2.1.3 (b) (i))

Nearside Headlamp aim too high and too far to the right. (4.1.2 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Rear Nail in tyre ()

Anti-roll bar pin or bush worn but not resulting in excessive movement Both sides rear D bush (5.3.4 (a) (i))

Brake pedal wearing smooth Splitting. (1.1.2 (c))

Exhaust noisy Aftermarket rear silencers fitted. (8.1.1 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced Corrosion visible on rear floor, under rear seat, in gap between undertrays. Unable to investigate further. (6.1.1 (c) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside front anti-roll bar linkage balljoints appear seized.

Oil leak, but not excessive Onto exhaust system and rack. No fumes detected in cabin during this inspection. (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both sides: Rear of rear inner wheelarches. (5.3.6 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Headlamp levelling device inoperative Not connected at bottom, and actuating arm balljoint is seized. Headlamp aims cannot be accurately checked or set until this is repaired. (4.1.5 (a))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Anti-roll bar pin or bush worn but not resulting in excessive movement Both sides rear D bush (5.3.4 (a) (i))

Brake pedal wearing smooth Splitting. (1.1.2 (c))

Exhaust mounting defective Rear silencer mounting rubbers are splitting. (6.1.2 (a))

Exhaust noisy Aftermarket rear silencers fitted. (8.1.1 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced Corrosion visible on rear floor, under rear seat, in gap between undertrays. Unable to investigate further. (6.1.1 (c) (i))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside front anti-roll bar linkage balljoints appear seized.

Oil leak, but not excessive Onto exhaust system and rack. No fumes detected in cabin during this inspection. (8.4.1 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Both sides: Rear of rear inner wheelarches. (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Ball joint nut locking device missing

Offside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Rear fog lamp not working (1.3.2b)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Engine management light on

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Headlamp levelling device inoperative (1.7.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Inner Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Anti-roll bar insecure (2.4.G.1)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Stop lamp not working (1.2.1b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Inner Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)