2002 Peugeot 206

Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Engine management lamp on

Fuel tank strap corroded

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Stop lamp not working (1.2.1b)

Items removed from driver's view prior to test

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Parking brake lever has little reserve travel (3.1.6b)

engine light on

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake load sensing valve stiff (3.6.E.3)

air bag light on dash

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Inner Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Inner Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Brake load sensing valve stiff (3.6.E.3)

air bag light on dash

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside rear brake juddering slightly (3.7.A.5b)

n/s/r tyre worn immer tread

oil leaks

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside rear brake juddering slightly (3.7.A.5b)

n/s/r tyre worn immer tread

oil leaks

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

n/s/f tyre edge wear slight wall damage

o/s/r brake judders slightly ( investigate)

Brake pedal has insufficient reserve movement (3.3.A.5)

Nearside rear brake recording little or no effort (3.7.B.5a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Rear Brake load sensing valve linkage seized (3.6.E.3)

Offside Headlamp aim too low and too far to the left. (1.8)

Nearside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)