2003 MG Zt

Brake servo defective or ineffective (1.1.10 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

chassis corroded

eml light on

floors corroded

n/s/r lower suspension arm corroded

sills corroded

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

n/s/r suspension lower arm corroded

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

rear suspension showing signs of corrosion but strength not adversely affected

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Headlamp levelling device inoperative (4.1.5 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

rear suspension showing signs of corrosion but strength not adversely affected

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

rear brake pipes corroded

rear suspension mtg areas corroded

rear suspension wishbones corroded

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

rear brake pipes corroded

rear suspension mtg areas corroded

rear suspension wishbones corroded

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear suspension wishbones corroded

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

rear suspension wishbones corroded

Nearside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

o/s/r sill corroded

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear sills corroded

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

Rear Exhaust system not adequately supported (7.1.1)

brake pipes corroded

rear brake pads and discs corroded

brake pipes corroded

rear brake pads and discs corroded

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

O/S/R Tyre has small splits on inner sidewall.

O/S/R Tyre has small splits on inner sidewall.

O/S/F Tyre outer sidewall has a cut in ,not showing the chords.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)