2005 MG Zt

Nearside Front Headlamp reflector slightly defective (4.1.1 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Front Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e))

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Headlamp aim too high (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake application uneven (3.7.B.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim too low (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)