2006 Jaguar X-type

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Service brake excessively binding (1.2.1 (f))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Floor (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Exhaust has a minor leak of exhaust gases rear (6.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe excessively corroded Both front to rear pipes badly corroded (1.1.11 (c))

Nearside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill holed (6.1.1 (c) (i))

Nearside Rear Suspension arm pin or bush excessively worn Trailing arm (5.3.4 (a) (i))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill holed (6.1.1 (c) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension arm pin or bush excessively worn Trailing arm (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Axle (6.2.2 (d) (i))

Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Axle (6.2.2 (d) (i))

Offside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Nearside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Inner Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Brake disc worn, pitted or scored, but not seriously weakened all (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Nearside Rear Shock absorber has a slightly worn bush (2.7.4)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Shock absorber has a slightly worn bush (2.7.4)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)