2006 Mazda MX-5

Front Subframe corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated Weak Clip (6.1.7 (g) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources Dim light source (4.7.1 (b) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe Corroded

Rear Suspension arms corroded not seriously weakened

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Subframe corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Nearside Rear Inner Drive shaft joint constant velocity boot severely deteriorated Weak Clip (6.1.7 (g) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources Dim light source (4.7.1 (b) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Subframe Corroded

Rear Suspension arms corroded not seriously weakened

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch to end cap of sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch to end cap of sill (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced Both sills (7.1.1 (a) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

engine management light on

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

engine management light on

engine management light on dash

Nearside door has slight damage

Front Brake pad(s) less than 1.5 mm thick inner (3.5.1g)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

engine management light on dash

Nearside door has slight damage

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre worn close to the legal limit +outer edge worn (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Front coil spring fractured (2.4.C.1a)

Nearside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear brake disc slightly pitted (3.5.1h)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Rear brake disc slightly pitted (3.5.1h)