2012 Toyota Aygo

Brake pedal wearing smooth (1.1.2 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing light cracking in tread (5.2.3 (d) (ii))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn BOTH sides (5.1.2 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sills (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting areas corroded (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement BOTH sides (5.3.4 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn bush deteriorated (5.1.2 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material between hose & cylinder (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area damaged but not considered excessive axle mounting area (5.3.6 (a) (i))

Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sills (BOTH sides) (6.1.1 (c) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement link bushes deteriorated (5.3.4 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits due to exhaust leak (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases rear silencer seams (6.1.2 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 155/65/14 (5.2.3 (d) (i))

Brake pipe corroded, covered in grease or other material both front to rear brake pipes corroded (near rear hose unions) (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement link bushes deteriorated (5.3.4 (a) (i))

Front Brake disc worn, but not excessively lipped and corroded on inner faces (1.1.14 (a) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Front Tyre worn close to legal limit/worn on edge both tyres close to minimum limit (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge close to minimum limit (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Tyre slightly damaged/cracking or perishing heavily cracked in outer shoulder (5.2.3 (d) (ii))

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Inner brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)