2003 Subaru Forester

Nearside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting repair covered in underseal sill (5.3.6 (a) (i))

under trays

underbody covered in dirt and underseal

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Under sill. Has plastic cover on outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Under sill .Has plastic cover on outer sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material Rear pipes to rear block connector (1.1.11 (c))

Images poor on both sides dip beams

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Lower Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm inner edge (5.2.3 (e)) DANGEROUS

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Lower Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Exhaust has a minor leak of exhaust gases at front and centre joint (6.1.2 (a))

Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Fuel filler neck corroded

Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases at mounting (6.1.2 (a))

Nearside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

exhaust heat shield insecure

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Rear registration plate dirty (6.3.1d)