2006 Honda Accord

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Front Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement Nearside and Offside (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge Nearside and Offside (5.2.3 (e))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement Nearside and Offside (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge Nearside and Offside (5.2.3 (e))

Brake disc worn, pitted or scored, but not seriously weakened Front & Rear (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brakes imbalanced across an axle (3.7.B.5b)