2010 Volvo S40

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Inner Steering rack gaiter missing or no longer prevents the ingress of dirt n/s/f steering rack gaiter not attached to steering rack (2.1.3 (g) (ii))

Nearside Rear Inner Tyre has a bulge, caused by separation or partial failure of its structure n/s/r tyre inner sidewall has 3 bulges in area if inner wheel rim 205/50 ZR17 (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp cleaning device for LED or HID headlamp inoperative (4.1.6 (a) (ii))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner wall (5.2.3 (d) (i))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner wall (5.2.3 (d) (i))

Offside Rear Upper Position lamp not working (4.2.1 (a))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

emissions too clean to be detected

Nearside Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres starting to wear out of shape on inner edges

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)