2005 Ford Ranger

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting floor area (6.2.2 (d) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner side section (5.3.6 (a) (i))

Rear Brake pipe excessively corroded from comp valve to flexi hose (1.1.11 (c))

Rear Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Offside Front Body panel corroded and likely to cause injury wing area (6.2.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Body panel corroded and likely to cause injury (6.2.1 (a) (i))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting (6.2.2 (d) (i))

Offside Front Cab or chassis has excessive corrosion, seriously affecting its strength within 30cm of a cab mounting Under bonnet and under offside wheel arch (6.2.2 (d) (i))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Valve stem slightly damaged (5.2.3 (j))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Exhaust mounting defective midle box (6.1.2 (a))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

brake hose braket lose

radiator cross member coroded

Front Vehicle structure is fractured but structural rigidity is not significantly reduced CROSS MEMBER UNDER RADIATOR (6.1.1 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced BODY MOUNTING (6.1.1 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material GREASE (1.1.11 (c))

Emissions not tested (8.2.2.2 (e))

Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users (8.2.2.2 (c)) DANGEROUS

Corrosion on various components

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive Rear diff (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Underside corrosion

Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Underside corrosion on various components

Front tyres wearing on edges

Underside corrosion on various components

Front Wipers poor but still wiping effectively.

Front Headlamp aim too low Both sides. (1.8)

Front Wipers poor but still wiping effectively.

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust silencer bracket broken

Offside Headlamp not working on dipped beam (1.7.5a)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

all tyres starting to get low

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)