2003 Honda Jazz

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened axle beam (5.3.3 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Integral body structure is corroded but structural rigidity is not significantly reduced Sill (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear axle corroding

Headlamp light intensity severely reduced Both (4.1.4 (a))

Nearside Front All position lamps not working (4.2.1 (a))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Upper Macpherson strut mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Upper Macpherson strut mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Brake fluid low

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear axle corroding

Front lower suspension arm bushes wearing

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear suspension components rusty and axle rusting

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Headlamp has a product on the light source so that the light output is severely reduced Both (1.7.5a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear registration plate faded (6.3.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front lower suspension arm bushes wearing

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear suspension components rusty and axle rusting

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake: efficiency below requirements (3.7.B.7)