2003 Ford Focus

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive nr sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive nr sill area (5.3.6 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension arm pin or bush excessively worn Trailing arm front bush (5.3.4 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

rear suspension corroded

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt split (2.1.3 (g) (ii))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Parking brake inoperative on one side both sides (1.4.1 (a))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

rear suspension corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions not tested Has Engine Mis-Fire (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Outer Sill Corroded (6.2.2 (d) (i))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Outer Sill Corroded (6.2.2 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

exhaust has broken brackets exhaust secure

front exhaust mounting brackets broken system supported ok

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

front exhaust mounting brackets broken system supported ok

Front Exhaust system not adequately supported (7.1.1)

Offside Headlamp aim too high (1.8)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

cut in nsr tyre side wall

front brake discs worn

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear coil spring corroded (2.4.C.1b)

cut in nsr tyre side wall

front brake discs worn

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

play nearside & offside steering rack arm

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

play nearside & offside steering rack arm

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)