2006 Jaguar S-type

Nearside Front Inner Road wheel slightly distorted rim edge (5.2.2 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front outer sill corroded at jacking point

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front outer sill corroded and holed at jacking point

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp aim not tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp aim not tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Inner Road wheel slightly distorted rim edge (5.2.2 (c) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front outer sill corroded at jacking point

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front outer sill corroded and holed at jacking point

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Rear Fluid leak, but not excessive diff fwd seal (8.4.1 (a) (i))

Nearside Rear Inner Suspension rod ball joint has slight play tie bar (5.3.4 (a) (i))

Central Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Lower Suspension arm pin or bush excessively worn fwd arm outer bushing (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Upper Suspension arm pin or bush excessively worn inner fwd and rear bushes (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Rear Fluid leak, but not excessive diff fwd seal (8.4.1 (a) (i))

Nearside Rear Inner Suspension rod ball joint has slight play tie bar (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement fwd arm fwd bush (5.3.4 (a) (i))

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

bonnet secondary catch faulty

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Front Shock absorber has an excessively worn bush lower bush (2.7.4)

Nearside Rear Lower Suspension arm has excessive play in a pin/bush arm outer bush (hub carrier lower bush ) (2.4.G.2)

Offside Rear Lower Suspension arm has excessive play in a pin/bush arm outer bush ( hub carrier lower bush ) (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

bonnet secondary catch faulty

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Under-trays fitted obscuring some underside components

Front registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Rear Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Engine covers fitted obscuring some components in the engine bay

Front Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Horn not working (1.6.2a)

Rear registration plate character(s) laid out in an incorrect format (6.3.4f)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Rear Suspension arm has slight play in a pin/bush (2.4.G.2)

exhaust emissions dont register on machine too clear

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust emissions dont register on machine too clear

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced across an axle (3.7.B.5b)

Front registration plate with character(s) which are not of equal width along their entire length (6.3.4a)

Offside Headlamp aim too low and too far to the right. (1.8)

Rear registration plate delaminated (6.3.1d)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)