2008 Toyota Aygo

Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn lower arm rear bush (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect possible bulb incorrectly fitted (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Brake pipe excessively corroded front to rear pipe (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Shock absorbers has slight external damage to the casing both sides (5.3.2 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Shock absorbers has a slightly worn bush both sides (5.3.2 (c))

Rear Sub-frame pin or bush worn but not resulting in excessive movement both axle bushes (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Headlamp aim too low (4.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear wheel bearing rough when rotated (2.6.1)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside rear tyre, slight cracking in tread.

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear tyre, slight cracking in tread.

Oil leak

Front wiper blade starting to tear.

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)