2009 Ford Ka

rear axel rusty

Windscreen washer provides insufficient washer liquid (3.5 (a))

rear axel rusty

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Lower Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge Strong advise (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Coil spring corroded both front (5.3.1 (b) (i))

Coil spring corroded both rear (5.3.1 (b) (i))

rear axle corroded

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

front number plate water marked

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

drivers seat wont tilt foward

exhaust corroded

front springs corroded

rear springs corroded

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases and clamp missing (7.1.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too high (1.8)

Rear Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)