2012 Vauxhall Insignia

Anti-roll bar linkage ball joint has slight play both front (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Tyre worn close to legal limit/worn on edge all four (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Shock absorbers has light misting of oil both rear (5.3.2 (b))

Nearside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front o/s/f and n/s/f top shocker mountings / bearing slightly noisy side to side movement . only when hanging down. jacked up

Rear o/s/r and n/s/r shocker mud covers adrift

Nearside Front Electrical wiring insecure and connectors likely to become disconnected abs wiring insecure. clip by ball joint broken (4.11 (a) (ii))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Position lamp not working sidelight inop (4.2.1 (a))

Nearside Rear Inner Brake pad(s) less than 1.5 mm thick pad low (1.1.13 (a) (ii)) DANGEROUS

Front o/s/f and n/s/f top shocker mountings / bearing slightly noisy side to side movement . only when hanging down. jacked up

Nearside Front Daytime running lamp

Nearside Front Inner Drive shaft joint worn, but not excessively cv joint play and nosey (6.1.7 (c) (i))

Offside Front Daytime running lamp

Rear o/s/r and n/s/r shocker mud covers adrift

Rear o/s/r and n/s/r shocks mud cover adrift

Nearside Rear Tyre has ply or cords exposed outer sidewall cut to cords (4.1.D.1b)

Nearside Rear Inner sidelight inop

Offside Rear Tyre worn close to the legal limit tyre balding outer edge (4.1.E.1)

Rear o/s/r and n/s/r shocks mud cover adrift

Front x2 washer jets part blocked

Rear shock n/s/r and o/s/r mud covers adift

Front Headlamp aim too high n/s/f and o/s/f high (1.8)

Front x2 washer jets part blocked

Rear Registration plate lamp not working x2 inop (1.1.C.1d)

Rear shock n/s/r and o/s/r mud covers adift

both front tyres worn close to limit in centre

Nearside Front Headlamp not working on dipped beam (1.7.5a)

both front tyres worn close to limit in centre

Under-trays fitted obscuring some underside components

front pads low

n/s/r tyre sidewall damaged x2 cuts .tread 1.00mm inner edge. nail in tread

o/s/r tyre bolding inner edge