2001 Mercedes-benz C

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine covers fitted obscuring some components in the engine bay

Play in steering rack inner joint(s)

Rear Brake pad(s) wearing thin (3.5.1g)

all brakepipes corroded

front reg plates cracked

sill cvers fitted

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

o/s/f tyre wearing bad on inner edge.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear fog lamp adversely affected by the operation of another lamp (1.3.2f)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

o/s/f tyre wearing bad on inner edge.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)