2002 Ford Escort

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

offside outer sill soft

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe inadequately clipped (3.6.B.1)

Exhaust emits an excessive level of metered smoke for a non-turbo charged engine (7.4.B.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Registration plate lamp shows direct white light to the rear (1.1.C.1f)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Front Brake pipe slightly corroded (3.6.B.2c)

Oil leak

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim too high (1.8)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp aim too high (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

indicator switch dose not self cancel

under side of van corroded

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension spring mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nail in offside front tyre