MOT Status
ExpiredMileage
104,117 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))
Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill area (5.3.6 (a) (i))
Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill area (7.1.1 (a) (i))
Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Nearside Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sill (5.3.6 (a) (i))
Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Suspension component mounting prescribed area is corroded but not considered excessive inner and outer sill (5.3.6 (a) (i))
Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))
Rear Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))
Nearside Rear Body panel damaged and likely to cause injury (6.2.1 (a) (i))
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))
Windscreen washer provides insufficient washer liquid (3.5 (a))
Oil leak, but not excessive gear box (8.4.1 (a) (i))
Front Oil leak, but not excessive (8.4.1 (a) (i))
Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Offside Rear Tyre tread depth below requirements of 1.6mm 205/55r16 (5.2.3 (e)) DANGEROUS
Front Oil leak, but not excessive (8.4.1 (a) (i))
Fuel Pipe/s corroded ()
Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Rear Integral body structure is corroded but structural rigidity is not significantly reduced subframe (6.1.1 (c) (i))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS
Fuel Pipe/s corroded ()
Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Rear Integral body structure is corroded but structural rigidity is not significantly reduced subframe (6.1.1 (c) (i))
Nearside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))
Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Central Rear Stop lamp(s) not working (4.3.1 (a) (ii))
Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))
Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))
Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Nearside Front Position lamp not working (4.2.1 (a) (ii))
Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))
Offside Front Position lamp not working (4.2.1 (a) (ii))
Parking brake efficiency below requirements (1.4.2 (a) (i))
Nearside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS
Offside Front Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS
Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))
both front and both rear flexi brake hoses ends showing corrosion
corrosion on both front and both rear flexi brake hoses ends
Tyre worn close to the legal limit (4.1.E.1)
Suspension arm has excessive play in a pin/bush (2.4.G.2)
Tyre worn close to the legal limit (4.1.E.1)
play noted in both front track control arms rear bushes
Front Brake pad(s) wearing thin (3.5.1g)
Child seat fitted not allowing full inspection of adult belt
Front bumper insecure
Nail in offside rear tyre
Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)
Offside Headlamp aim too low and too far to the right. (1.8)
Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)
Child seat fitted not allowing full inspection of adult belt
Front bumper insecure
Nail in offside rear tyre
Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)
Nail in nearside rear tyre
T C S warning lamp on
How Reliable is the Mazda 3?
Based on 2,040,939 MOT tests across 164,053 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
BN56 CMO is a 2006 Mazda 3 in Blue with a 1,598cc petrol engine. This vehicle has been through 22 MOT tests with a personal pass rate of 63.6%.
Across all 2006 Mazda 3 models, the average MOT pass rate is 74.6% with a typical mileage of 70,278 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Mazda 3 fails its MOT is tyre tread depth below requirements of 1.6mm, accounting for 40,716 recorded failures. If you're considering buying BN56 CMO, it's worth having these areas checked by a mechanic before committing.
The Mazda 3 typically stays on UK roads for around 22 years. At 20 years old, this Mazda 3 is approaching the upper end of the typical lifespan for this model.
Frequently Asked Questions
How do I check the history of BN56 CMO?
You can check the full history of BN56 CMO by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was BN56 CMO registered?
BN56 CMO is a 2006 Mazda 3, first registered on 5 September 2006.
Is BN56 CMO safe to buy?
The MOT history for BN56 CMO shows 22 tests with a 63.6% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does BN56 CMO have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on BN56 CMO. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.