2007 Yamaha Ybr 125

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Drive chain excessively loose (6.1.7 (c) (i))

Headlamp aim too low (4.1.2 (a))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Horn not working (7.7 (a))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Headlamp aim too high (4.1.2 (a))

Front Tyre has a lump or bulge caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Horn not working (7.7 (a) (ii))

Steering headbearing has excessive wear or free play (2.2.2 (f) (i))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Offside Footrest missing rubber cover (6.2.12 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Drive chain excessively loose (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Hydraulic brake control feels spongy (3.1.4a)

Front suspension assembly component excessively bent both fork legs bent (2.3.1)

Headlamp aim too low and too far to the left. headlight loose (1.6)

Rear Drive chain sprocket worn to excess (6.2.1e)

Wheel alignment incorrect which adversely affects the handling yokes out of alignment (2.5.1)

n/s foot peg and gear lever bent. difficult to reach gear lever with foot

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Drive chain excessively loose (6.2.1d)

Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Horn not working (1.7.3a)

nearside riders footrest rubber missing

Drive chain excessively loose (6.2.1d)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Drive chain excessively loose (6.2.1d)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

head light beam not tested

Front Footrest insecure (6.2.1a)

Front Front mudguard insecure (2.3.7)

Front suspension fouling which affects the movement of the front suspension. (2.3.6a)

Handlebar deformed (2.1.1b)

Headlamp aim too high and too far to the right. (1.6)