2008 Suzuki Swift

Central Front Lower Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Rear Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Lower Exhaust mounting defective (6.1.2 (a))

Offside Rear Upper Exhaust mounting defective (6.1.2 (a))

Rear Brake hose has slight corrosion to ferrule Both sides (1.1.12 (f) (i))

Central Front Lower Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Central Rear Upper Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Lower Exhaust mounting defective (6.1.2 (a))

Front Position lamp not working Both sides (4.2.1 (a) (ii))

Offside Rear Upper Exhaust mounting defective (6.1.2 (a))

Rear Brake hose has slight corrosion to ferrule Both sides (1.1.12 (f) (i))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Front Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate dirty

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Hydraulic brake calliper leaking and braking performance affected (1.1.16 (b) (ii)) DANGEROUS

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides pitted (1.1.14 (a) (ii))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Nail in tyre ()

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn rear bush falling out of arm (5.3.4 (a) (i))

Windscreen washer not working (3.5 (a))

Driver's seat moving inadvertently (6.2.5 (b) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened both sides pitted (1.1.14 (a) (ii))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush cracked (5.3.4 (a) (i))

Nearside Rear Nail in tyre ()

Rear Brake pipe slightly corroded on axle (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

rear brake pipes corroded

Nearside Rear coil spring broken (2.4.C.1a)

Parking brake lever has little reserve travel (3.1.6b)

rear brake pipes corroded

brake pipes and hoses coated

Rear Direction indicators missing (1.4.A.2b)

Rear fog lamp missing (1.3.2a)

Rear position lamp(s) missing (1.1.A.3a)

Registration plate lamp not fitted (1.1.C.1b)

brake pipes and hoses coated

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Parking brake lever has no reserve travel (3.1.6b)