2011 Citroen C3

Nearside Front Anti-roll bar pin or bush excessively worn bonding (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn bonding (5.3.4 (a) (i))

Anti-roll bar insecure and impairing directional stability fouling offside caliper on full lock (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Suspension arm pin or bush worn but not resulting in excessive movement MAIN\BUSHS\BOTH\SIDES\PERISH##POOR## (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge BOTH\TYRES EDGED\UNEVEN ##POOR## (5.2.3 (e))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Parking brake inoperative on one side AND BIND (1.4.1 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Front Suspension arm pin or bush worn but not resulting in excessive movement MAIN\BUSHS\BOTH\SIDES\PERISH##POOR## (5.3.4 (a) (i))

Front Tyre worn close to legal limit/worn on edge BOTH\TYRES EDGED\UNEVEN ##POOR## (5.2.3 (e))

All direction indicators slightly discoloured (4.4.3 (a))

Front oil leak

injector number 1 leaking pressure slightly

Oil leak, but not excessive nearside driveshaft seal (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Tyre slightly damaged/cracking or perishing both front (5.2.3 (d) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge tyre wearing on inner edge (5.2.3 (e))

exhaust hanger corroded not insecure

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)