2018 Isuzu D-max

Brake pipe corroded, covered in grease or other material all brake pipe ends corroded (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Brake pipe corroded, covered in grease or other material all brake pipe ends corroded (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases back box (6.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Upper Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Position lamp with a multiple light source more than 1/2 not functioning (4.2.1 (a) (ii))

Nearside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Brake pipe excessively corroded behind flap (1.1.11 (c))

Nearside Rear Upper Brake pipe excessively corroded into flexy pipe (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS