2002 Peugeot 206

Tyre worn close to legal limit/worn on edge both front inner edge (5.2.3 (e))

exhaust strap corroded

compensator damp but no signs of leaks during test

Brake lining(s) less than 1.5 mm thick both front (1.1.13 (a) (ii)) DANGEROUS

compensator damp but no signs of leaks during test

Offside Front Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

front tyre treads low and age cracks in rears

slight play nsf anti roll bar link

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Brake load sensing valve seized (3.6.E.3)

Centre Exhaust has a major leak of exhaust gases to rear joint (7.1.2)

Front Exhaust has a major leak of exhaust gases to centre exhaust joint (7.1.2)

Offside Stop lamp not working (1.2.1b)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Upper Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Front constant velocity joint is insecure (2.5.C.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

both rear tyres perished but no cords or deep cuts exposed

engine mounting slighly perished

Rear exhaust section started to corrode

Nearside Rear position lamp(s) not working (1.1.A.3b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Rear exhaust section started to corrode

Indicator switch faulty (1.4.A.1)

Nearside front lower arm bush started to seperate

Front Brake pad(s) wearing thin (3.5.1g)

Rear silencer corroded and started to blow

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)