2003 Toyota Yaris

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Bumper slightly insecure

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both sides (6.2.2 (d) (i))

Front Bumper insecure (6.1.4 (a) (i))

Nearside Front Headlamp insecure (4.1.1 (c))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Both sides (6.2.2 (d) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Nail in tyre ()

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn bush (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn bush (5.3.4 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Headlamp levelling device inoperative (4.1.5 (a))

Front Brake hose slightly deteriorated Both sides (3.6.B.4d)

Front Outer Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement Both sides (2.4.G.2)

Headlamp aim beam image obviously incorrect both sides (1.8.A.1b)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Rear Tyre has a tear, caused by separation or partial failure of its structure Both sides (4.1.D.1b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

front brake excessively fluctuating (3.7.B.3)

Front Brake hose slightly deteriorated Both sides (3.6.B.4d)

Front Outer Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement Both sides (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Centre Rear Seat belt damaged sufficient to significantly weakened the webbing (5.2.2a)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

cuts in near side front tyre sidewall just within limits