2003 Ford Focus

Fluid leak, but not excessive coolant bottle cracked (8.4.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

advise poor head lights

Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting both outer sills by monts (6.2.2 (d) (i))

advise poor head lights

advise poor paton head lights week sills

Front Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Steering linkage ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) DANGEROUS

advise poor paton head lights week sills

Rear Brake pipe corroded, covered in grease or other material beam sill closer panles heavley under sealed (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material beam sill closer panles heavley under sealed (1.1.11 (c))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Front Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

advise crossion axel rearea

advise poor paton head light osf floor pan greev mould on

Central brake disc modified and seriously weakened front worn out sharp scoored (3.5.1n)

Rear registration plate character(s) likely to be misread (6.3.4b)

advise poor paton head light osf floor pan greev mould on

Nearside Rear Stop lamp not working (1.2.1b)

Rear Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Centre Rear Stop lamp obscured more than 50% (1.2.1c)