1999 Saab 9-3

Bonnet primary retaining device insecure unable to open bonnet (under bonnet items not checked) (3.1 (c))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Anti-roll bar linkage pin or bush excessively worn bush worn (5.3.4 (a) (i))

Offside Front Body component corroded and likely to cause injury bonnet corroded sharpe edge (6.2.1 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate does not conform to the specified requirements wrong colour and spaces incorrect (0.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault air bag (7.1.6 (a))

Lower Engine mounting damaged but not to excess (6.1.8 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside Rear Suspension component mounting repair covered in underseal chassis (5.3.6 (a) (i))

Nearside Rear wheel binding

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting repair covered in underseal chassis (5.3.6 (a) (i))

Central Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Central Stop lamp(s) with a multiple light source more than 1/2 not functioning (4.3.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Coil spring mounting corroded and seriously weakened (5.3.1 (b) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases silencer (6.1.2 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Coil spring mounting corroded but not seriously weakened top (5.3.1 (b) (i))