2005 Subaru Forester

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Front Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Rear Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced rear subframe (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both anti roll bar mounting bushes (5.3.4 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced both inner wheel arches corroded near suspension mounting (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Emissions not tested Due to exhaust leak (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Brake hose ferrule excessively corroded (1.1.12 (f) (i))

Offside Rear Suspension arm attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Service brake is causing the steering wheel to severely pull one way (1.2.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

corrosion various places under vehicle

various brake pipes corroded/covered in grease

Offside Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

offside front tyre outer + inner edges worn

offside rear tyre outer edge worn