1983 Mazda RX-7

N/S/ floor/chassis holed

Nearside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear fog lamp not working (1.3.2b)

Offside Registration plate lamp not working (1.1.5c)

Steering pivot point has excessive play (2.2.B.1g)

Nearside Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Vehicle structure has slight corrosion (6.1.A.1)

Offside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Steering pivot point has excessive play (2.2.B.1g)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear fog lamp not working (1.3.2b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Centre Drag link end ball joint has excessive play (2.2.B.1f)

Nearside Rear brake disc excessively pitted (3.5.1h)

Nearside Steering arm damaged and unserviceable (2.2.C.1d)

Nearside front brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear brake disc excessively pitted (3.5.1h)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Both front chassis brails in poor condition

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Oil leak

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Offside Front Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Offside Rear Rear passenger seat cannot be secured in the upright position. (6.2.3)

Position lamp switch faulty (1.1.A.1)

all suspension bushes heavily perished

cannot get headlamps to switch off(see switch fault?)

engine cuts out and will not restart(occasionally)

heavy surface corrosion under and around car