2003 Peugeot 206

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Central Rear Seat belt retracting mechanism defective (5.2.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired outer sill (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Check front wheel alignment (tracking)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Emissions not tested due to exhaust blow (7.4.B.1)

Exhaust has a major leak of exhaust gases centre/rear join (7.1.2)

Nearside Front Headlamp aim beam image obviously incorrect bulb in wrong? (1.8.A.1b)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Obligatory mirror insecure (8.1.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm outer edge (4.1.E.1)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Fuel tank insecure (7.2.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

front tyres wearing on outer edges but not to excess

Exhaust emits excessive smoke or vapour of any colour (7.4.B.4)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Side repeater not working (1.4.A.2c)

Nearside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Nearside rear brake binding (3.7.B.1)

Engine covers fitted obscuring some components in the engine bay

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

front tyres wearing on outer edges but not to excess

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Oil leak

Rear Brake load sensing valve seized (3.6.E.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear fog lamp not working (1.3.2b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Engine covers fitted obscuring some components in the engine bay

Headlamp masks/converters fitted

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Engine covers fitted obscuring some components in the engine bay

Headlamp masks/converters fitted

Offside Rear Direction indicator slightly discoloured (1.4.A.2f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

front brake discs slightly worn

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear position lamp(s) obviously incorrectly positioned (1.1.A.3a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Side repeater incorrect colour (1.4.A.2f)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

front brake discs slightly worn

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Registration plate lamp not working (1.1.5c)

Brake load sensing valve linkage seized (3.6.E.3)

Front Headlamp aim too high (1.8)

handbrake travel high

Front Headlamp aim too high (1.8)

Nail in nearside rear tyre

Centre Rear fog lamp not working (1.3.2b)

Nearside Front Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)