2004 Rover 45

Emissions unable to be completed exhaust major leak middle section (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting floor rotten jacking point front left (6.2.2 (d) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (surface corrosion) (1.1.11 (c))

Front Inner brake pads wearing thin

Fuel Pipe/s corroded ()

Nearside Front tyre worn low on tread

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear tyre worn low on tread

Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arms (large compliance bushes) (5.3.4 (a) (i))

nearside and offside front floor pans/inner sill areas corroded

unable to inspect nearside and offside front outer sills due to sills covered in skirts/covers

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor area (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor area (5.3.6 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge worn smooth outer edge (5.2.3 (e))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive rear mountain floor area (2.4.A.3)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive rear mountain floor area (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Stop lamp not working (1.2.1b)

n/s/f tyre wearing on inner edge

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

n/s/f tyre wearing on inner edge

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

o/s/f tyre worn on inner edge

o/s/r tyre tread split

Vehicle's internal headlight adjuster altered to recheck lights

both rear tyres cracking on tread

srs light illuminated

Nearside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Vehicle's internal headlight adjuster altered to recheck lights

both rear tyres cracking on tread

srs light illuminated

Front Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

both rear tyres cracking on tread

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

o/s/f tyre worn on inner edge

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

both front tyres wearing on edges