2011 Audi Q5

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Lower Suspension arm likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Lower Suspension arm pin or bush excessively worn rear of 2 inner (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen washer not working (3.5 (a))

Offside Front Inner Suspension arm pin or bush excessively worn track control arm (5.3.4 (a) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement track control arm (5.3.4 (a) (i))

Rear registration plate delaminated but not likely to be misread (6.3.1d)

engine covers and under trays fitted

engine rev limiter fitted

exhaust emissions too clean to give a reading

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Rear Brake pad(s) wearing thin (3.5.1g)