2012 Volkswagen Scirocco

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Rear Lower Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Nail in tyre

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Tyre slightly damaged/cracking or perishing both side (5.2.3 (d) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Nearside Rear Nail in tyre

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Side repeater missing (4.4.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect kick up to the right (4.1.2 (c))

Offside Headlamp aim too far to the right (4.1.2 (a))

Offside Headlamp insecure (4.1.1 (c))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Non obligatory mirror damaged missing

Nearside Rear Nail in tyre

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)