2003 Mercedes-benz Vito

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust emissions exceed level of metered smoke for a turbo charged engine (8.2.2.2 (b))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Front Headlamp aim too high both (4.1.2 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sills (7.1.1 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sills (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sills (5.3.6 (a) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner/outer sills (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sills (5.3.6 (a) (i))

Offside Rear Body has an unsafe modification lamp casing (6.2.1 (d) (i))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Parking brake inoperative on one side (1.4.1 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill corroded outside prescribed area (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill corroded outside prescribed area (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Tyre worn close to legal limit/worn on edge all (5.2.3 (e))

Front Inner Suspension component pin or bush slightly worn both sides (5.3.4 (a) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Nearside Front inner/outer sills slightly corroded

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front to rear inner/outer sills slightly corroded

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Shock absorbers has slight external damage to the casing both (5.3.2 (b))

Exhaust emissions test aborted because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced rigger (7.1.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced rigger (7.1.1 (a) (i))

Parking brake inoperative on one side (1.4.1 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Inner Suspension component pin or bush slightly worn both sides (5.3.4 (a) (i))

Hazard warning switch faulty (4.4.2 (a) (i))

Nearside Front inner/outer sills slightly corroded

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front to rear inner/outer sills slightly corroded

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Shock absorbers has slight external damage to the casing both (5.3.2 (b))

hazard lamp switch deteriorated

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Subframe mounting prescribed area is excessively corroded outer rigger (2.4.A.3)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Front Windscreen wiper does not clear the windscreen effectively both wipers split (8.2.2)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Seat belt anchorage prescribed area is excessively corroded outer sill (5.2.6)

Nearside Stop lamp not working (1.2.1b)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Macpherson strut worn but not seriously weakened (2.4.G.1)

Offside Front Macpherson strut worn but not seriously weakened (2.4.G.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Obligatory mirror seriously obscured affecting the rear view (8.1.2a)

Offside Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Front Macpherson strut worn but not seriously weakened (2.4.G.1)

Offside Front Macpherson strut worn but not seriously weakened (2.4.G.1)

EML on

Nearside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Offside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Exhaust has a major leak of exhaust gases front pipe x 2 (7.1.2)

Horn not working (1.6.2a)

Nearside Headlamp aim too low (1.8)

Nearside Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength inner sill (2.4.A.3)

Nearside Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Headlamp aim too low (1.8)

Rear position lamp(s) adversely affected by the operation of another lamp Brake lights always on (1.1.A.3f)

Stop lamp remains on when the brakes are released both (1.2.1e)

EML on

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Offside Front Shock absorber has a slightly worn shock absorber pivot (2.7.4)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Side repeater slightly discoloured (1.4.A.2f)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Direction indicators not working (1.4.A.2c)

Offside Front Headlamp aim too low (1.8)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake load sensing valve seized (3.6.E.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Offside Side repeater slightly discoloured (1.4.A.2f)

both front strutt mounts noisey

both outer sills rashed with rust and damaged

brake peddle rubber worn

Nearside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

both front strutt mounts noisey

both outer sills rashed with rust and damaged

brake peddle rubber worn

damaged to n/s and o/s sills

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Stop lamp not working (1.2.1b)

damaged to n/s and o/s sills

Rear Registration plate lamp not working (1.1.C.1d)

rear Brake discs worn

rear Brake discs worn

Horn not working (1.6.2a)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Lower Ball joint has slight play (2.2.B.1f)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside front brake application uneven (3.7.B.2)

Horn not working (1.6.2a)