2012 Ford Focus

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Anti-roll bar linkage missing (5.3.3 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Shock absorbers insecurely attached (5.3.2 (a) (i))

Central Exhaust shield missing where fitted as original equipment creating a risk of fire (6.1.3 (e)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Exhaust has a major leak of exhaust gases cat pipe flexi (6.1.2 (a))

Nearside Front Body component damaged and likely to cause injury door mirror cover/indicator lense (6.2.1 (a) (i))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm 215/50r17 (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Nail in tyre ()

Oil leak, but not excessive (8.4.1 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Windscreen washer not working (3.5 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Side repeater missing (4.4.1 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

O/S/F inner drive shaft seal leaking

coolant level low