2013 Peugeot 208

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Parking brake inoperative on one side low reading (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Tyre(s) with different aspect ratios are fitted on the same axle. (5.2.3 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Headlamp insecure (4.1.1 (c))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt split (6.1.7 (g) (ii))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Road wheel fixing missing (5.2.1 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement REAR BUSH. (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement REAR BUSH. (5.3.4 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded BOTH REAR. (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Tyre slightly damaged/cracking or perishing Both NS & OS (5.2.3 (d) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords cut on tread (5.2.3 (d) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)