2018 Toyota Proace

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Service brake excessively fluctuating Easy 60 KG fluctuation. Judging by wheel trim. Is there any mounting flange damage? (1.2.1 (e))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure All within tread area (5.2.3 (d) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Offside Rear Tyre slightly damaged Slight structural defect towards inner edge tread area. As marked on side wall with yellow crayon (5.2.3 (d) (ii))

Spare tyre defective Under inflated ()

Exhaust has a minor leak of exhaust gases Catalyst to DPF flange area. New clamp/nut and bolt recommended (6.1.2 (a))

Nearside Rear Position lamp with a multiple light source up to 1/2 not functioning Upper lamp inoperative (4.2.1 (a) (i))

Offside Rear Brake hose slightly chafed Hose mounting bracket damaged and causing hose to foul on suspension arm. Almost through to steel braiding. Rigid part of brake pipe also insecure to axle (1.1.12 (b) (i))

Offside Rear Service brake fluctuating, but not excessively Approx' 35 to 40 KG fluctuation (1.2.1 (e))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords In two places and within, inner edge tread area. Benefit of the doubt given (5.2.3 (d) (i))

front tyre treads getting low

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS